ON THE ESTABLISHMENT OF A TYPIFIED PROGRAMMING TECHNIQUE FOR NUMERICAL CONTROL

邓寿鹏; 肖骞; 黄祚阶; 余祖镛

您当前的位置：

首页 >

文章列表页 >

ON THE ESTABLISHMENT OF A TYPIFIED PROGRAMMING TECHNIQUE FOR NUMERICAL CONTROL

更新时间：2025-12-08

- ON THE ESTABLISHMENT OF A TYPIFIED PROGRAMMING TECHNIQUE FOR NUMERICAL CONTROL
- Acta Electronica Sinica Issue 1, Pages: 14-22(1978)
- 作者机构：
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Published：1978
- 稿件说明：
移动端阅览
[1]邓寿鹏,,,,,,,,,,,肖骞,,,,,,,,,,,黄祚阶,,,,,,,,,,,余祖镛.论数控编程的典型化技术[J].电子学报,1978(01):14-22.

邓寿鹏, 肖骞, 黄祚阶, et al. ON THE ESTABLISHMENT OF A TYPIFIED PROGRAMMING TECHNIQUE FOR NUMERICAL CONTROL[J]. Acta Electronica Sinica, 1978, (1): 14-22.
[1]邓寿鹏,,,,,,,,,,,肖骞,,,,,,,,,,,黄祚阶,,,,,,,,,,,余祖镛.论数控编程的典型化技术[J].电子学报,1978(01):14-22. DOI：

邓寿鹏, 肖骞, 黄祚阶, et al. ON THE ESTABLISHMENT OF A TYPIFIED PROGRAMMING TECHNIQUE FOR NUMERICAL CONTROL[J]. Acta Electronica Sinica, 1978, (1): 14-22. DOI：

摘要

本文提出的数控编程典型化技术

是在对任意二维空间图形的几何形状及几何量进行特征分析的基础上建立起来的。大量实践证明:这种典型化技术利用普通的计算工具

就能十分有效地解决复杂图形、特殊图形和非圆曲线图形的数控编程

而不必限于使用费用昂贵的通用电子计算机。

Abstract

The typified programming technique for numerical control

described in this paper

is established on the basis of characteristic analysis of geometric configurations and dimensions of any two-dimensional patterns. A great deal of facts have proved that through this typified technique the numerical control programming of complex

special and non-circular curve patterns can be efficiently solved by the mere use of common computing tools

instead of expensive general electronic computers.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

No data

Related Author

No data

Related Institution

No data

⁰