Design of a 2.4GHz CMOS Radio Transceiver for IEEE 802.15.4 (ZigBee) Standard Applications

LI Di; YANG Yin-tang; SHI Zuo-chen; LIU Yang

doi:10.3969/j.issn.0372-2112.2015.05.028

您当前的位置：

首页 >

文章列表页 >

Design of a 2.4GHz CMOS Radio Transceiver for IEEE 802.15.4 (ZigBee) Standard Applications

更新时间：2025-07-16

- Design of a 2.4GHz CMOS Radio Transceiver for IEEE 802.15.4 (ZigBee) Standard Applications
- Acta Electronica Sinica Vol. 43, Issue 5, Pages: 1021-1027(2015)
- 作者机构：
  
  西安电子科技大学微电子学院,陕西,西安,710071
- 作者简介：
- 基金信息：
  
  National Natural Science Foundation of China (No.61334003);Fundamental Research Funds for the Central Universities (No.K5051225006)
- DOI：10.3969/j.issn.0372-2112.2015.05.028
  CLC： TN402TN47
- Published：2015
- 稿件说明：
移动端阅览
LI Di, YANG Yin-tang, SHI Zuo-chen, et al. Design of a 2.4GHz CMOS Radio Transceiver for IEEE 802.15.4 (ZigBee) Standard Applications[J]. Acta Electronica Sinica, 2015, 43(5): 1021-1027.
DOI：

LI Di, YANG Yin-tang, SHI Zuo-chen, et al. Design of a 2.4GHz CMOS Radio Transceiver for IEEE 802.15.4 (ZigBee) Standard Applications[J]. Acta Electronica Sinica, 2015, 43(5): 1021-1027. DOI： 10.3969/j.issn.0372-2112.2015.05.028.

摘要

本文提出了一种适用于IEEE 802.15.4标准的2.4GHz免认证ISM频段的全集成CMOS射频收发机.接收机采用低中频结构以降低功耗、提高灵敏度

发射机则采用直接上变频结构以降低设计复杂度和功耗.芯片采用0.18

m 1P4M CMOS工艺以及MIM电容制造

供电电压1.8V.测试结果显示

在误包率为1%时

接收机灵敏度达到了-97dBm

发射机输出至100差分天线端口的最大输出功率为+3dBm.接收模式和发射模式下的电流功耗分别为17mA和19mA

芯片面积3.3mm2.8mm.

Abstract

A highly integrated CMOS transceiver was presented for 2.4GHz unlicensed ISM (Industrial

Scientific and Medical) band compatible to the IEEE 802.15.4 Standard.Low-IF topology was adopted in the receiver for low power consumption and high sensitivity while direct up-conversion in transmitter for low complexity.The transceiver chip has been fabricated in a 0.18

m 1P4M CMOS (Complementary Metal Oxide Semiconductor) technology with MIM (Metal-Insulator-Metal) capacitors and supplied by a single 1.8V.The experimental results show that the receiver achieves a sensitivity of -97dBm for PER(Packet Error Rate) of 1% and the transmitter provides a max power output of +3dBm into 100 differential antenna port.Thi

s transceiver dissipates 17mA in receive mode and 19mA in transmit mode and occupies an area of 3.3mm2.8mm.

关键词

Keywords

references

Views

1954

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on Indoor Location Technology Based on Back Propagation Neural Network and Taylor Series

Related Author

ZHANG Hui-qing

SHI Xiao-wei

DENG Gui-hua

GAO Xue-jin

REN Ming-rong

Related Institution

College of Electronic and Control Engineering, Beijing University of Technology

Beijing Division, China Nuclear Power Technology Research Institute

College of Electronic and Control Engineering Beijing University of Technology Beijing China

Beijing Division China Nuclear Power Technology Research Institute Beijing China

⁰