Study of a Ku-Band Backward Wave Oscillator Characteristics with Low Magnetic Field of 0.3T

SHAO Jian-bo; XIE Hong-quan; LI Zheng-hong; MA Qiao-sheng

doi:10.3969/j.issn.0372-2112.2016.09.005

您当前的位置：

首页 >

文章列表页 >

Study of a Ku-Band Backward Wave Oscillator Characteristics with Low Magnetic Field of 0.3T

更新时间：2025-07-16

- Study of a Ku-Band Backward Wave Oscillator Characteristics with Low Magnetic Field of 0.3T
- Acta Electronica Sinica Vol. 44, Issue 9, Pages: 2057-2061(2016)
- 作者机构：
  
  1. 西南科技大学理学院,四川,绵阳,621010
  2. 中国工程物理研究院应用电子学研究所, 高功率微波技术重点实验室,四川,绵阳,621900
  3. 西南科技大学理学院,四川,绵阳,621010
  4. 中国工程物理研究院应用电子学研究所高功率微波技术重点实验室,四川,绵阳,621900
- 作者简介：
- 基金信息：
  
  National Natural Science Foundation of China (No.61271109)
- DOI：10.3969/j.issn.0372-2112.2016.09.005
  CLC： TN125
- Published Online：25 September 2016，
  
  Published：2016
- 稿件说明：
移动端阅览
SHAO Jian-bo, XIE Hong-quan, LI Zheng-hong, et al. Study of a Ku-Band Backward Wave Oscillator Characteristics with Low Magnetic Field of 0.3T[J]. Acta Electronica Sinica, 2016, 44(9): 2057-2061.
DOI：

SHAO Jian-bo, XIE Hong-quan, LI Zheng-hong, et al. Study of a Ku-Band Backward Wave Oscillator Characteristics with Low Magnetic Field of 0.3T[J]. Acta Electronica Sinica, 2016, 44(9): 2057-2061. DOI： 10.3969/j.issn.0372-2112.2016.09.005.

摘要

为了实现相对论返波管振荡器（RBWO）永磁包装，本文采用Magic模拟软件在0.5T低磁场相对论返波管（RBWO）器件结构基础上，通过在器件慢波结构末端添加一个部分反射腔，减小电子束质量对束波转换影响，即减小引导磁场的影响，实现了Ku波段相对论返波管振荡器0.3T磁场下运行.当电子束束压600kV、电子束束流7kA时，模拟得到器件输出微波功率740MW，效率18%.尽管该器件的效率低于0.5T磁场下的效率（25%），然而0.3T引导磁场在工程上更容易实现.结合小型化的脉冲功率源进行实验研究，当二极管束压580kV、束流6.5kA，实验获得功率600MW，频率13.10GHz，脉宽25ns的微波输出，该器件的研制可以促进高功率微波（HPM）系统小型化的发展.

Abstract

In order to realize the relativistic backward wave oscillator(RBWO) permanent magnet packaging

simulation software Magic is used and based on the structure of the relativistic backward wave oscillator(RBWO) with low magnetic field of 0.5T

through adding a partially reflecting cavity at the end of the device's slow wave structure to reduce the effect of the quality of electron beam on the beam-wave conversion

that is

to reduce the effect of guiding magnetic field

so this paper realized the Ku band relativistic backward wave oscillator normal operation at 0.3T.When the electron beam is 600kV and the beam current is 7kA

the output microwave power of 740MW and the efficiency of 18% are obtained in the simulation software Magic.Although the efficiency of the RBWO at 0.3T is lower than that at 0.5T(25%)

guiding magnetic field of 0.3T is easier to realize in engineering.Experiment on the miniaturization of pulse power source

when the diode is 580kV and the beam is 6.5kA

achieves output power of 600MW and the frequency of 13.10 GHz with the corresponding pulse width of 25ns.

关键词

Keywords

references

Views

398

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Highly Integrated Three-Dimensional Structure Ultra-Wideband LTCC Power Divider

Miniaturized Phase-Shifting Power Divider Based on Slow-Wave Substrate Integrated Waveguide

Design of Novel CMOS Coupled Filters Based on Spoof Surface Plasmon Polaritons

A VHF/UHF Low Profile Miniaturized Vertically Polarized Antenna for Airborne Communications

Miniaturized Equal-Length Equal-Width Phase Shifter Based on Slow-Wave Half-Mode Substrate Integrated Waveguide

Related Author

HU Shan-wen

SHI Gang

WANG Zi-cheng

JIANG Jun-yi

CHEN Xiao

ZHAN Zhong-jie

HUANG Wen

WU Jie-min

Related Institution

College of Electronic and Optical Engineering College of Flexible Electronics (Future Technology), Nanjing University of Posts and Telecommunications

School of Optoelectronic Engineering， Chongqing University of Posts and Telecommunications

The 38th Institution of China Electronics Technology Group Corporation

Silicon Austria Labs， Linz

State Key Laboratory of Millimeter Waves， Southeast University

⁰