电子学报 ›› 2017, Vol. 45 ›› Issue (6): 1506-1512.DOI: 10.3969/j.issn.0372-2112.2017.06.032

• 学术论文 • 上一篇    下一篇

基于循环平稳差异的直扩信号盲提取抗干扰方法

朱行涛1,2, 刘郁林3, 栗铁桩2   

  1. 1. 国防信息学院, 湖北武汉 430010;
    2. 重庆通信学院, 重庆 400035;
    3. 总参通信工程设计研究所, 辽宁沈阳 110005
  • 收稿日期:2015-10-08 修回日期:2016-01-10 出版日期:2017-06-25
    • 作者简介:
    • 朱行涛 男,1982年生于湖北随州.现为国防信息学院博士研究生.主要研究方向为军事信息学、智能信号处理及通信抗干扰等.E-mail:mynazhu@126.com;刘郁林 男,1971年生于四川简阳.现为总参通信工程设计研究所教授、博士生导师.主要研究方向为盲信号处理、无线传感器网络等.E-mail:spliuyl@uestc.edu.cn;栗铁桩 男,1979年生于河南泌阳.现为重庆通信学院军事信息网络工程教研室主任.主要研究方向为网络工程等.E-mail:li_tiezhuang@126.com
    • 基金资助:
    • 新世纪优秀人才支持计划资助 (No.NCET-11-0873); 重庆高校创新团队建设计划资助 (No.KJTD201343)

Anti-jamming Method by Blindly Extracting of Direct Sequence Spread Spectrum Signal Based on Cyclostationary Difference

ZHU Xing-tao1,2, LIU Yu-lin3, LI Tie-zhuang2   

  1. 1. Academy of National Defense Information, Wuhan, Hubei 430010, China;
    2. Chongqing Communication College, Chongqing 400035, China;
    3. Institute of Communication Engineering Design of General Staff, Shenyang, Liaoning 110005, China
  • Received:2015-10-08 Revised:2016-01-10 Online:2017-06-25 Published:2017-06-25

摘要:

提出一种基于循环平稳差异的直扩信号盲提取抗干扰方法.针对源信号在统计域上的近似独立性,构建直扩通信盲源分离抗干扰模型,基于源信号的循环平稳差异,利用循环自相关函数的典型极值点定义一个用于区分直扩信号和干扰的二阶循环差异度特征参数,通过比较该特征参数的大小进行模式识别,提取出直扩信号而抑制掉干扰,达到抗干扰的目的.仿真结果表明:当信干比(SJR)为-40dB、归一化信噪比(NSNR)为9dB时,直接解扩/解调信号的误比特率约为IE-0.3,而本文所提抗干扰算法误比特率(BER)低至IE-3,可从强干扰中有效分离并提取出直扩信号.

关键词: 阻塞干扰, 扫频干扰, 循环平稳, 盲源分离, 抗干扰

Abstract:

This paper presents a cyclostationary difference-based anti-jamming method by blindly extracting direct sequence spread spectrum signal.Aiming at approximate independence among source signals,an anti-jamming model based on blind source separation is established for direct sequence spread spectrum communication.And then,by using typical extreme points of cyclic autocorrelation function,a characteristic parameter called second-order cyclic difference degree is defined based on cyclostationary difference to distinguish between direct sequence spread spectrum signal and jamming.Finally pattern recognition is used to extract expected signal and suppress jamming by comparing the values of characteristic parameter,so as to achieve the purpose of anti-jamming.Simulation results show that,when the NSNR (Normalized Signal to Noise Ratio) is 9 dB and the SJR (Signal to Jamming Ratio) is -40 dB,the direct de-spreading/demodulation signal achieves the bit error rate (BER) of nearly IE-0.3,while the proposed algorithm achieves the bit error rate of as low as IE-3,which can extract the direct spread signal from the strong jamming effectively.

Key words: barrage jamming, sweep-spot jamming, cyclostationary, blind source separation, anti-jamming

中图分类号: