电子学报 ›› 2013, Vol. 41 ›› Issue (1): 166-170.DOI: 10.3969/j.issn.0372-2112.2013.01.029

• 科研通信 • 上一篇    下一篇

一种高速并行采样实时校正方法研究

叶芃, 曾浩, 田书林, 向川云, 潘卉青, 王厚军   

  1. 电子科技大学自动化工程学院,四川成都611731
  • 收稿日期:2009-04-24 修回日期:2012-08-22 出版日期:2013-01-25
    • 作者简介:
    • 叶芃 男。1973年5月出生,四川成都人。副教授。1995年、2001年和2010年在电子科技大学分别获工学学士、工学硕士和工学博士学位。现为电子科技大学自动化工程学院副院长,主要研究方向为高速数据采集与信号处理、数字存储示波器。 E-mail: ye_peng007@163.com曾 浩 男。1979年8月出生,四川都江堰人。副研究员。2002年、2005年和2010年在电子科技大学分别获工学学士、工学硕士和工学博士学位。主要研究方向为高速数据采集与信号处理、数字存储示波器等。
    • 基金资助:
    • 中央高校基本科研基金 (No.A03007023801217,No.A03008023801080)

Research on the Real-time Calibration Technology for High-Speed Parallel Sampling

YE Peng, ZENG Hao, TIAN Shu-lin, XIANG Chuan-yun, PAN Hui-qing, WANG Hou-jun   

  1. School of Automation, University of Electronic Science and Technology of China, Chengdu, Sichuan 611731, China
  • Received:2009-04-24 Revised:2012-08-22 Online:2013-01-25 Published:2013-01-25
    • Supported by:
    • Basic Research Fund for the Central Universities (No.A03007023801217, No.A03008023801080)

摘要: 并行交替采样带来的非均匀误差严重影响采集性能。本文建立了并行交替采集系统的数学模型,实现了一种幅度非均匀误差校正的归一化算法,在误差校正系统中引入可程控参考校正源,再利用查表法同时校正系统的偏置和增益失配误差,然后对时间非均匀性参数进行估计,并通过高精度可编程时钟延时网络对其修正。实验结果表明,该校正方法实时性好,降低了硬件设计难度和成本,提高了系统性能。

关键词: 并行交替采样, 实时校正, 时间非均匀, 幅度非均匀

Abstract: Errors of time non-uniform and amplitude non-uniform in parallel sampling seriously influence the performance of the system.This paper established a mathematical model of parallel alternating acquisition system,and realized a normalized correction algorithm for non-uniform amplitude error.This method not only introduced programmable reference voltage source,but also corrected the offset and gain error at the same time by the method of look-up table.Finally,the calibration system estimate the time of non-uniformity parameters,which can be corrected by controlling the high precision programmable clock delay network.The correction method proposed in the thesis,after testing and verifying,is proved to increase the correction performance with high real-time performance,while reducing the design difficulty of hardware and system costs.

Key words: parallel sampling, real-time calibration, time non-uniform, amplitude non-uniform

中图分类号: