电子学报 ›› 2018, Vol. 46 ›› Issue (12): 2896-2904.DOI: 10.3969/j.issn.0372-2112.2018.12.011

• 学术论文 • 上一篇    下一篇

基于衰减量调节的VHF/UHF频段发射机互调发射抑制比测量方法

何洪涛, 耿利飞, 范秋虎, 李玉旗   

  1. 中国洛阳电子装备试验中心, 河南洛阳 471003
  • 收稿日期:2017-03-21 修回日期:2018-03-09 出版日期:2018-12-25
    • 作者简介:
    • 何洪涛 男,1968年5月出生,河南洛阳人.2014年获北京航空航天大学微波与电路专业博士学历,现为中国洛阳电子装备试验中心高级工程师.主要从事电磁环境效应、电磁环境效应试验及评估方面的研究.E-mail:13526974382@163.com;耿利飞 男,1984年1月出生,河北赞县人.2012年获军械工程学院武器系统与运用工程专业博士学位,现为中国洛阳电子装备试验中心工程师.主要从事电磁环境效应试验及评估、电磁仿真方面的研究.E-mail:369250810@163.com;范秋虎 男,1979年8月出生,黑龙江密山人.2010年获国防科学技术大学电子信息与通信工程专业硕士学位,现为中国洛阳电子装备试验中心工程师.主要从事电磁环境效应、电磁环境效应试验及评估方面的研究.;李玉旗 男,1971年8月出生,山东东明人.1996年获重庆大学精密仪器专业学士学位.现为中国洛阳电子装备试验中心工程师.主要从事电磁环境效应试验技术研究.
    • 基金资助:
    • 总装备部"十二五"重点预研项目 (No.51333050301)

The Intermodulation Attenuation Ratio Measuring Method for VHF/UHF Band Transmitters Base on Attenuation Adjusting

HE Hong-tao, GENG Li-fei, FAN Qiu-hu, LI Yu-qi   

  1. Luoyang Electronic Equipment Test Center of China, Luoyang, Henan 471003, China
  • Received:2017-03-21 Revised:2018-03-09 Online:2018-12-25 Published:2018-12-25
    • Supported by:
    • 12th Five-year Plan Key Pre-research Project of PLA General Armament Department (No.51333050301)

摘要: 设计了以可调衰减器和定向耦合器为核心器件的发射机互调发射电平测量链路,建立了定向耦合器各端口的互调发射信号模型,分析了互调发射信号功率随可调衰减器衰减量变化的规律.依据理论分析结果,研究了干扰信号源的一次反射互调信号功率、被测发射机二次反射互调信号功率和互调信号耦合功率等误差项的消除方法,设计了基于可调衰减器衰减量调节的、适用不同互调发射类型的互调发射抑制比测量流程.对实际电台的测量结果表明,测量结果与理论分析结论完全一致,验证了本文提出的互调发射抑制比衰减量调节测量方法合理性和准确性.

关键词: 互调发射, 互调发射抑制比, 可调衰减器, 误差项消除方法, 测量流程

Abstract: The measurement for transmitter inter-modulation (IM) is developed, taking a directional coupler and an adjustable attenuator as core equipment. The IM signal models at each port of the directional coupler are established; and the regularity of how the IM signal level at coupler ports change with the attenuation of the adjustable attenuator is analyzed. According to theoretical analysis, the paper investigates methods for elimination of several error factors, like the first-order reflected IM signal from the interference signal source, and the second-order reflected IM signal from the transmitter under test and coupling signal power; and then gives the detail measurement procedures relies on the attenuation adjustment of attenuator. A practical measurement of a broadcasting station indicates that using the proposed method, a very good agreement of measurement and theoretical analysis can be achieved, which validates the rationality and accuracy of proposed method.

Key words: transmitter intermodulation, intermodulation attenuation ratio, adjustable attenuator, error items cancelling methods, IM measuring method procedure

中图分类号: